Thingiverse
Wall Panel Heater Spacer
par Magnanimator
0
Téléchargements
1
Likes
0
Makes
Wall Heater Spacer for 300W Heater Panels
Recommend PETG to handle the heat but PLA should be OK as well as low wattage heaters run well below PLAs melting point. The spacing is important so that airflow between the wall and the heater is established to ensure convection flow to keep the room warm.
The spacers are open on one side to accommodate screws being mounted first and then pushing the spacer over the threaded screw.
Recommend PETG to handle the heat but PLA should be OK as well as low wattage heaters run well below PLAs melting point. The spacing is important so that airflow between the wall and the heater is established to ensure convection flow to keep the room warm.
The spacers are open on one side to accommodate screws being mounted first and then pushing the spacer over the threaded screw.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
