MakerWorld
Other Hobby & DIY
Vai al Modello
Wall passthrough for cables - adjustable length
232
Download
92
Likes
90
Makes
Adjustable passthrough for walls 3 different sizes;17cm to approx. 30cm (6.69 - 11.81 inches) 12cm to approx. 20cm (4.72 - 7.87 inches) 9cm to approx. 14cm (3.54 - 5.51 inches) 2 versions of each size; With and without screw holesI would select the version where the lowest number corresponds most with the wall thickness. For instance, if the wall is 12.5cm then select the 12-20cm version. If it is 18cm, then select the 17-30cm version. Inside diameter is 15.5mm (0.61 inches) Hole size needed for the largest part is 22mm (0.87 inches). It will also work for the smallest part (19mm)You may use a very thin tape on the inner part to lock the parts together. In my case this is not needed and it holds up well without screws.It depends on how much force you intend to use when you pull cables throughI printed this in PETG for outdoor use and some flexibility. PLA should work fine for indoor use.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
