WALL-PI 5

A simple 2 3D printed part design.Front display assembly frame and a back shell. The 5 inch DSI touch screen ( https://www.amazon.com/dp/B0CXTFN8K9?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1 ) mounted (up side down) by sliding into the front frame.At this point it is a good idea to flash and insert the SD card with your preferred OS into the Raspberry pi now as it will be difficilt to remove after mounting.The Raspberry pi board can then be mounted with the included standoffs and screws to the back of the screen module. Now the Screen can be connected to the raspberry pi using the included ribbon cable. The case supports space for a “normal” height HAT module. I personally used a raspberry pi 3 together with a digital audio interface board like shown belowThis fits fine in the case - but your mileage may vary. Now two M3 heat inserts can be inserted into the back shell part. here:Now the front frame assembly can be mounted into the back shell by sliding it into the back shell and using 2 M