Thingiverse
Wall shelf router & switch mount
von xsysiu
0
Downloads
0
Likes
0
Makes
Pet-G filament is preferred.
20-30% infill to ensure stiffness.
4mm screws are required for the switch.
To ensure compatibility with most devices, I didn't design any switch spacers; I used self-adhesive foam. Supports are recommended.
20-30% infill to ensure stiffness.
4mm screws are required for the switch.
To ensure compatibility with most devices, I didn't design any switch spacers; I used self-adhesive foam. Supports are recommended.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!