Thingiverse
Wanhao 4s Z-Axis Preloader
von sonrix
1
Downloads
2
Likes
0
Makes
I saw a Z-Preloader for the CTC Bizer. I tried it on the Duplicator 4s, but it did not fit.
So I made my own, as there was a bid of movement in the Z-Axis.
You put two top parts on the top between frame and the z-linear rails. And two on the bottom at the same place.
---
Don't tip me. It is for free.
So I made my own, as there was a bid of movement in the Z-Axis.
You put two top parts on the top between frame and the z-linear rails. And two on the bottom at the same place.
---
Don't tip me. It is for free.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
