Thingiverse
Wanhoa i3 Mosfet bracket
by rcflyers
28
Downloads
10
Likes
2
Makes
Bracket for the MOSFET upgrade on a Wanhao i3 V2.
The 4 upstands for the MOSFET have a 2.5mm hole in them so you can screw an M3 screw straight in to them
No drilling required, just remove the 4 circuit board screws and slip this bracket over the 2 case studs nearest to the LCD display.
Then refit the board and connect the wiring.
The 4 upstands for the MOSFET have a 2.5mm hole in them so you can screw an M3 screw straight in to them
No drilling required, just remove the 4 circuit board screws and slip this bracket over the 2 case studs nearest to the LCD display.
Then refit the board and connect the wiring.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!