Thingiverse
Warcry Tracker/Dashboard with Optional Storage Box
von Dalankar
2
Downloads
3
Likes
0
Makes
I took FluffyB's Warcry FluffTracker, turned it into a Lid, and built a Storage Box underneath it.
When printing I like to turn on Ironing For All Top Surfaces.
When printing the lid you need to Enable Supports. I recommend Normal Supports.
When printing the bottom I recommend you use a Brim.
The 16mm variant comes with 4 different bottom Storage Boxes to choose from and is designed to accept 3mm x 1mm round magnets.
The 12mm & 14mm variants are only top Tops (Dashboard/Tracker) with no Box options and no magnet holes.
When printing I like to turn on Ironing For All Top Surfaces.
When printing the lid you need to Enable Supports. I recommend Normal Supports.
When printing the bottom I recommend you use a Brim.
The 16mm variant comes with 4 different bottom Storage Boxes to choose from and is designed to accept 3mm x 1mm round magnets.
The 12mm & 14mm variants are only top Tops (Dashboard/Tracker) with no Box options and no magnet holes.
Dalankar veröffentlicht auch auf
44 zusätzliche Modelle auf 3 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
