Warframe Corpus Locker - No AMS needed

Model based of off Warframe Corpus Locker by Jayhawk2255. Model has been divided into coloured parts, doesn't need AMS.Side panels and top blue thingy doesn't need any glue, should just tightly fit into their spots. Small elements on the front are a very tight fit, so they might need a bit of “encouragement” to fit into their spot. I use my clipping pliers to push them in. Make sure you cut off the excess filament at the base.The remaining 3 elements need a bit of glue to stick into their place. First glue in the black panel and the bigger orange (brown in my case) element, then the smaller orange piece so it fits into the notch.Black side panels can be difficult to put into place depending on how much your filament expands during printing. If they also need a bit of an encouragement, put them more/less in their place on the pins on both sides, push as much as you can with your fingers and use a leverage to push them all the way:You should be able to put a lot of weight on it w