Thingiverse
Warré Hive Robber Guard
von sfusion
50
Downloads
26
Likes
0
Makes
My Warré hive has been getting pestered by wasps, this guard is an attempt to make it more difficult for the wasps for enter and easier for the bees to defend.
There are 11 9mm entry/exit holes which restricts traffic down.
Previously entrance area was 120*20mm [2400mm²]
With the guard on the entrance area is reduced to 11*63.62mm [699.82mm²] a 70% reduction in area.
The idea with the porch roof is to make it more difficult for wasps to get a good flight path.
Feedback welcome.
There are 11 9mm entry/exit holes which restricts traffic down.
Previously entrance area was 120*20mm [2400mm²]
With the guard on the entrance area is reduced to 11*63.62mm [699.82mm²] a 70% reduction in area.
The idea with the porch roof is to make it more difficult for wasps to get a good flight path.
Feedback welcome.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
