Warsun T7 Shell

Exact copy of the shell of the Warsun T7 torch.I've only printed this in abs.Make sure your shrinkage, contour and hole compensation are set, along with flow ratio etc. Note, I use orca slicer and sunlu abs. I Had to create a bambu profile to upload. I reccomend using Orca slicer and using my listed print settings. I'm sure you can get the same print quality in bambu studio however, just make sure whatever slicer you use that your flament is dialed in. Leave a comment with feedback if any issues. Print settings.0.4mm nozzleArachne wall generatorWalls inner/outerPrecise wallPrecise Z heightEnable brimNo support0.2mm layer height