Thingiverse
Wasatch Bong 69 PSU Mount
por derikwhittaker
2
Descargas
1
Likes
0
Makes
PSU Mount for Genius Long Range Controller board(s).
This PSU Mount is designed to fit the standard hole dimensions for PSU (verified on Alitove and Meanwell) (should fit any PSU with 150mm between mounting holes).
The design has an in-cut on the bottom to allow for nuts/bolts to rest above the PSU. The design only uses top screw holes on the PSU to allow the bottom to be used for PSU mounting. Will include 4 3mm offset spacers to be used between the controller and the mount to allow for the controller to be raised off of the mount surface.f
This PSU Mount is designed to fit the standard hole dimensions for PSU (verified on Alitove and Meanwell) (should fit any PSU with 150mm between mounting holes).
The design has an in-cut on the bottom to allow for nuts/bolts to rest above the PSU. The design only uses top screw holes on the PSU to allow the bottom to be used for PSU mounting. Will include 4 3mm offset spacers to be used between the controller and the mount to allow for the controller to be raised off of the mount surface.f
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
