Thingiverse
washer-dryer drain tee
von willps
18
Downloads
19
Likes
0
Makes
do you have one drain for 2 dryer outlets? I did!
This is a case study for a 3d printer.. who knows what contractor would have posed what solution.. but it could have gotten ugly lol.
If the Tee's length is too much you can slice it with the part slightly below the print bed to adjust it.
This is a case study for a 3d printer.. who knows what contractor would have posed what solution.. but it could have gotten ugly lol.
If the Tee's length is too much you can slice it with the part slightly below the print bed to adjust it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!