Watch Winder Geared

This is a remix/completion of this watch winder: https://www.thingiverse.com/thing:2974687 . I really liked the design but unfortunately on the original thing there were a lot of parts missing, so I created the missing ones and changed some things about the existing ones.

The electronics are based on this guide: https://www.instructables.com/3D-Printed-Watch-Winder-ATtiny85Stepper/ . However, I also added a lithium battery to and a switch to turn the winder on and off.

You will need to change the orientation for minimum supports. Depending on the strength of your springs you should print the watchholder in 100%

In addition to the 3D printed parts you will need the electronics from the guide as well as:

- 1x 608 Bearing for the winder gear
- 1x screw that fits the bearing incl matching washers and nut (M8)
- 2x 4mm rods for the watch holder, (length depends on the length of your wrist band), you will need to cut threads into the ends of the rods (maybe threaded rod will w