Thingiverse
Water cap
von Field_Ready
5
Downloads
9
Likes
0
Makes
This is a prototype threaded cap to seal off the excess water output of a diesel water pump.
The thread is 1.66mm pitch (~15TPI) , about 1" OD. This is close to 3/4BSP but slightly smaller and finer pitch.
It was designed in South Sudan by Ben Savonen for Field Ready, as part of a project with Water for South Sudan. only one part has been printed and no usage feedback has been received, so its unclear how effective this design is at this moment.
The thread is 1.66mm pitch (~15TPI) , about 1" OD. This is close to 3/4BSP but slightly smaller and finer pitch.
It was designed in South Sudan by Ben Savonen for Field Ready, as part of a project with Water for South Sudan. only one part has been printed and no usage feedback has been received, so its unclear how effective this design is at this moment.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!