water dispenser

For this water dispenser you need:
- This 3D object
- A 500 ml bottle
- A straw
- Glue

This is how it works:
1. Download this 3D object.
2. Print it out.
3. Cut a hole in the bottom of the bottle (diameter approx. 5 mm).
4. Cut off part of the straw and glue it into the hole (note: the glue must not come into contact with the water)
5. Open the bottle at the lid and fill it with a drink
6. Place the bottle in the hole in the 3D object
7. Place a mug/cup under the bottle with the drink inside
8. Open the lid so that the drink comes out
9. As soon as there is enough of the drink in the mug/cup, close the bottle again.