Thingiverse
Water Feeder Mount
por Olenscho
1
Descargas
1
Likes
0
Makes
A stand/mount for rabbit/rodent water feeders.
If the bottom and top parts are printed separately, no supports are needed (except for maybe the screw holes).
Measurements:
100x88x79mm
Maximal diameter of the "bottle" is < 70mm, with the max width from the flat part to the opposite side should be 63mm. The lid/cork can be up to 33mm in diameter.
The screw holes are 3mm in diameter.
If the bottom and top parts are printed separately, no supports are needed (except for maybe the screw holes).
Measurements:
100x88x79mm
Maximal diameter of the "bottle" is < 70mm, with the max width from the flat part to the opposite side should be 63mm. The lid/cork can be up to 33mm in diameter.
The screw holes are 3mm in diameter.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
