MakerWorld
Organizers
Go to Model
Water Flosser Stand/Drying Rack
89
Downloads
28
Likes
75
Makes
This is a simple stand/drying rack I made for a Philips cordless power flosser 3000! I have 4 different models and 4 different print profiles. One is a closed base with no drip chute. The other three have water run off chutes on the middle, left and right of the base of the model. That way you can choose the style that fits your needs! There is built in draft to allow the water drips to run towards the chutes. I personally haven't seen too much water drip out of mine after use but its a nice touch to add the run off chutes. The diameter of the peg is 35mm an its 105mm tall. The outer diameter of the 3 peg stand is 68mm, the inner diameter of the 3 peg stand is 44mm and is 90mm tall. The dimensions of the base is 78mm X 158mm. I printed this with Bambu Lab PLABoost MeA simple boost makes me smile and drives me to make more of these fun prints! Thank you!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
