Thingiverse
Water Hose Guide
par Froggysoft
5
Téléchargements
6
Likes
0
Makes
The hose, coming from my ground water source, going to the hydrophore pump, was starting to kink coming out of the source tube.
I tried to minimize the design, but it still is a 100mm outside, 70mm inside tube, and a 32mm hose, so I designed it so it would just fit on my printerbed.
Nevertheless it still needs a lot of filament; about 120 meters (1.75) per half/side.
I tried to minimize the design, but it still is a 100mm outside, 70mm inside tube, and a 32mm hose, so I designed it so it would just fit on my printerbed.
Nevertheless it still needs a lot of filament; about 120 meters (1.75) per half/side.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !