Thingiverse
Water level sensor mount
von blueblade
149
Downloads
103
Likes
0
Makes
bolt on mount to attach a float switch to water bin/trashcan/tank.
should work on any container with a lip 10mm wide or narrower.
supports built into design, should snap off easily.
should print well with no additional supports or such needed at .2mm layer or smaller and .4mm nozzle (not tested with other nozzles) in most any material.
should work on any container with a lip 10mm wide or narrower.
supports built into design, should snap off easily.
should print well with no additional supports or such needed at .2mm layer or smaller and .4mm nozzle (not tested with other nozzles) in most any material.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
