Creality Cloud
Water powered Wankel engine
von
0
Downloads
0
Likes
0
Makes
This is a water powered Wankel engine and you need a water pump to use this.1.slice and print the engine with pla and no support needed.2. use m4 screws to tighten the engine and a bearing in the rotor.3.connect the water pump to a source of waterand connect it to the inlet of the engine
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
