Thingiverse
water sprayer V3
by winkit
191
Downloads
144
Likes
0
Makes
A sprayer suitable for Gardena Qick Connect.
Printed from ABS and successfully tested.
Part 2 is placed over part 4, then part 5 is screwed on.
I have coated the thread of part 4 with acetone to glue both parts together.
The seals I printed from very soft TPU.
Part 3 is pushed into Part 1 and screwed in a bit. A little grease can not hurt, so it's easier to turn. Then both parts are pushed together and screwed.
If you steam the parts with acetone, they should be waterproof.
Printed from ABS and successfully tested.
Part 2 is placed over part 4, then part 5 is screwed on.
I have coated the thread of part 4 with acetone to glue both parts together.
The seals I printed from very soft TPU.
Part 3 is pushed into Part 1 and screwed in a bit. A little grease can not hurt, so it's easier to turn. Then both parts are pushed together and screwed.
If you steam the parts with acetone, they should be waterproof.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!