Thingiverse
Water tap key
door Reiver
12
Downloads
7
Likes
0
Makes
A key for a crane with a 6mm square. It can be printed without any support. Print it with 100% infill for maximum strength of the part. Probably also works fine with 50%.
The dimensions of the original key are:
* Outside cylinder diameter: 12mm
* Outside cylinder height: 12mm
* Inside square length and width: 6.1mm
* Inside square dept: 10mm
There is a version with and without a hole.
The dimensions of the original key are:
* Outside cylinder diameter: 12mm
* Outside cylinder height: 12mm
* Inside square length and width: 6.1mm
* Inside square dept: 10mm
There is a version with and without a hole.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!