Thingiverse
Watering Can Nozzle
von Caipi
20
Downloads
11
Likes
0
Makes
This is nozzle design that will be put over a watering can's spout and helps watering hydroponic plants by guiding the water into the pot's side holes preventing from spilling water.
It fits on watering cans where the spout is around 22mm diameter.
It's best printed with TPU flex material so it will be tight around the can's spout and doesn't leak.
The nozzle can be printed without support. With support it might be a nicer print, however I never tested support with TPU material.
It fits on watering cans where the spout is around 22mm diameter.
It's best printed with TPU flex material so it will be tight around the can's spout and doesn't leak.
The nozzle can be printed without support. With support it might be a nicer print, however I never tested support with TPU material.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
