Thingiverse
Watering Can Spout
door Petal3D
19
Downloads
51
Likes
1
Makes
I managed to break the spout of an otherwise good watering can. The size of the connection is about 26.6mm diameter and 18mm long.
Print using PLA filament, preferably with 100% infill. Supports are not required, as there are internal ribs. You may optionally use a brim to increase print-bed adhesion.
Minimal post-processing is required.
Print using PLA filament, preferably with 100% infill. Supports are not required, as there are internal ribs. You may optionally use a brim to increase print-bed adhesion.
Minimal post-processing is required.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
