Slicer Discord
Wave Pen Carousel and Caddy – 3D printable model from MakerWorld MakerWorld
Office

Wave Pen Carousel and Caddy

by LoboCNC · Office
77 Downloads
45 Likes
45 Makes
Go to Model
If you are one of us who spends more time playing with your desk accessories than you spend actually working, this pen carousel is for you! As you rotate the carousel, your favorite pen will present itself for the taking. It also has a little stack of trays in the center for all your desk doodads like rubber bands, paper clips, etc.. Prints and assembles easily with no supports or added hardware. You can use any length pen with this, but to get the best wave-effect, the end of the pen should sit flush with the top of carousel. Each pen actually sits on a little booster block that gets pushed upward by the wave generator in the base. I've provided three different height booster blocks: the shortest for longer pens, the tallest for shorter pens and the mid-sized for medium length pens. Just slide the best-fitting booster into each tube before inserting your pen. Then, the whole carousel slides over the post on the base. Lastly, you can optionally add some non-skid feet to the bottom of t
Category
Office
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Why?
no supports
Support-free Single piece Hardware needed
Supports 0/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

LoboCNC also publishes on

313 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection