Thingiverse
Waveshare 1.5 Inch 128X128 OLED Case
by flyboy2017za
9
Downloads
3
Likes
0
Makes
Needed a case to hold the Waveshare 128X128 OLED screen for my boost gauge project.
OLED is screwed to the back plate with 5mm long 3mm countersink screws.
Top cover is a tight fit that can be glued on if you wish.
I did not make any cut-outs for the cable, as the display can be rotated in any direction and depends on whether you use the pin-outs or connector.
Easily cut out for uour own needs
OLED is screwed to the back plate with 5mm long 3mm countersink screws.
Top cover is a tight fit that can be glued on if you wish.
I did not make any cut-outs for the cable, as the display can be rotated in any direction and depends on whether you use the pin-outs or connector.
Easily cut out for uour own needs
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!