Waveshare Pi Compute Module 4 (CM4) PoE Board CASE

This is a case I designed from scratch around the 3D model file for the Waveshare Compute Module 4 PoE IO Board.

I designed the Lid of this case to hold a 60mm fan directly above the CM4 with a 15mm tall heatsink on top of the CM4. I printed this case out just fine on my Ender 3 Pro and it fits the board perfectly.

I did NOT create any openings in the case for the DSI or CSI connectors, or for the MicroSD Card slot, as I do not need to use those connections. I did however create one extra hole on the back left corner for a U.FL (IPEX) to RP-SMA antenna connector.

I have included the Fusion 360 file (*.f3d) so you are free to make modifications to this case as you see fit.

The Lid could still use some work, as I have not created any way for it to stay securely attached to the case yet. Right now, it just sort of friction fits into place.

Note: The Waveshare Compute Module 4 PoE IO Board comes equipped with four brass standoffs on the bottom of the board. This case was des