Thingiverse
WD40 straw
by Mahoganut
86
Downloads
49
Likes
0
Makes
This printed quite well on my Flashforge Finder but it did need a little sanding to fit my WD40 can. I think this is due to the entry/exit points during the print, as the straw is so small it appears slightly misshapen. I had it in my can after about 20 seconds of sanding.
I had no need for a long straw but you can make it longer in your slicer if you require.
Speed: 50mm/s
Infill: 100%
Layer Height: 0.08mm
I had no need for a long straw but you can make it longer in your slicer if you require.
Speed: 50mm/s
Infill: 100%
Layer Height: 0.08mm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
