Thingiverse
Wear Resistant Filament Guide
door ronthomp
10
Downloads
5
Likes
0
Makes
My PLA guide from scrap parts was great, but it wore a groove in it. This design uses a 5/16" or 8mm flat washer as the wear surface. When it wears, you can rotate the washer to a new surface.
I designed this for my Ronthomp Mendel, but it will work on others.
I designed this for my Ronthomp Mendel, but it will work on others.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
