Thingiverse
Weather Vane
von justin_brock
0
Downloads
0
Likes
0
Makes
A little weather vane made out of circles.
You will need:
Minimum 200mm x 200mm Build Plate
x1 6001 Ball Bearing
Glue
Assembly:
Print the two sides of the Vane
Glue the two sides together
Print the base
Insert 6001 ball bearing into the base's center (press fit)
Insert the glued vane pieces into the ball bearing
You will need:
Minimum 200mm x 200mm Build Plate
x1 6001 Ball Bearing
Glue
Assembly:
Print the two sides of the Vane
Glue the two sides together
Print the base
Insert 6001 ball bearing into the base's center (press fit)
Insert the glued vane pieces into the ball bearing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!