Weatherproof Box Riser + Rail Bracer

This 3D-printed riser and rail repair is designed to restore receptacle mounting support on older outdoor weatherproof gang boxes where the original top/bottom device rails have rusted or broken. It also adds extra device depth to improve wire clearance and reduce crowding behind duplex or GFCI receptacles, while also providing a clean extension surface for many in-use weatherproof covers. The model supports two print and install approaches. The one-piece version prints as a single sleeve for better weather resistance and a simpler seal. The splited 3-peices version prints as three parts—a top section, a bottom rail bracer, and a vertica bracer to secure the top and bottom parts together—for easier installation when conduit fittings are difficult to manage. )* when printed as one piece, the brace is not required.) For outdoor durability, ASA is recommended; PETG is also suitable, while PLA is not recommended for sun/heat exposure.This model is also customizable. All parameters below ar