Webcam Light Bar

Attaches to Ender 3 Z-axis Camera Mount for Logitech C270 by Zotty.
Screws could be used, but I just used a small binder clip.
Re-purposed the LED strips in a cheap battery light found in a local hardware store.
I plug it into USB (my Raspberry PI running Octoprint).
By default it was way too bright (comes with approx a 1 ohm limit resistor).
I use three 47 ohm resistors in parallel instead.
I used double sided foam tape to affix the LED strips and a drop of thick CA for the resistors.