Thingiverse
Wedco Closed Gas Cap
von Toleman
3
Downloads
1
Likes
0
Makes
I designed these gas caps to fit Wedco fuel cans as pictured.
One cap has a groove to accept a 2"diameter by .200" thick gasket/washer. The other cap has no Groove. Printed with no support with PETG material.
I sourced my silicone rubber washers from reverse osmosis water filter gaskets.
One cap has a groove to accept a 2"diameter by .200" thick gasket/washer. The other cap has no Groove. Printed with no support with PETG material.
I sourced my silicone rubber washers from reverse osmosis water filter gaskets.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
