Thingiverse
Weed box
por TheBigGizmo
1.2k
Descargas
1.2k
Likes
5
Makes
Weed box
First print the weed logo, lower it 1mm so only the logo and outer line prints, then change filament, print the top of the box on top of the logo whit Z-hop on set to 0.6 .
The hinges uses M2X20 screws
Print whit no support.
0.2 Layer Height 0.4 nozzle
20% Infill
6 walls for more strength
Share a picture! Thank you!
First print the weed logo, lower it 1mm so only the logo and outer line prints, then change filament, print the top of the box on top of the logo whit Z-hop on set to 0.6 .
The hinges uses M2X20 screws
Print whit no support.
0.2 Layer Height 0.4 nozzle
20% Infill
6 walls for more strength
Share a picture! Thank you!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!