Thingiverse
Weed Whacker Attachment Hanger
von jwd164
4
Downloads
1
Likes
0
Makes
I wanted to hang my weed whacker attachments on the wall in my garage. I decided to design a snap-in receiver for the attachments and screw an aluminum T-slot rail to the wall. The hanger I designed will slide into a 20mm T-slot rail. I used a u-joint so the attachments could lean against the wall at whatever angle was best.
This hanger was created in Openscad and can be modified for any desired wall hanger. The ujoint library (https://www.thingiverse.com/thing:125939) used was designed by https://www.thingiverse.com/celer/about
This hanger was created in Openscad and can be modified for any desired wall hanger. The ujoint library (https://www.thingiverse.com/thing:125939) used was designed by https://www.thingiverse.com/celer/about
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
