Weee Power strip holder

Simple holder for Lidl power strip. Use 3x ~7mm head diameter countersunk bolt/screw to hold it in place. I use it as under desk holder because the size of the holes on stip itself is realy small, this holds it way better.It is pretty hefty design to be printed out from abs/petg. Height is a little smaller than should so it clamps nicely the powerstrip to desk.For ease of installation start with taller part. Install it first, than put the smaller part with single hole where it needs to be and just bolt it with strip inside.For removal of strip just loosen all bolts a little (if needed remove one from taller part also) and slide out your strip.