Weekly Pill Container Labeled by day - Plus single

I have some store bought pill organizers that are big, bulky and expensive. Since I like creating 3d Models I figured I could do better, so I did using only 66g of filament! This model includes a few things: First, the lids snap to latch securely. Its a tight latch which might seem too tight at first but things like this always wear down over time so I played it safe and made them tight to begin with to allow them to loosen up. Second, I put an actual hinge on them vs just a thin piece of plastic bending over and over again like my store bought versions. Third, each slot opens separately. There are several designs on Makerworld that slide open which means your pills for another day could flop out on the floor. This way all pills you do not intend to use will stay put. Fourth, each slot has a curved bottom on the side you want to take the pills out of. This means you can easily slide them out, no more getting stuck in a bottom corner. Finally, the example in the pictures was printed in