Weighted Base Headphone Stand

Hey Everyone!I designed this stand with functionality and stability in mind. The base is wide and weighted (weights are optional) with about 375g of copper BB's. It will hold your headphone securely protecting them from tipping over if bumped. Print Specifications:PLA0.4 mm nozzle0.2 mm layer height4 wall loops10-35% infill supports where needed Supplies:350-450g weight I chose to use BB's but i guess you could use any source of weight (small fishing weights ect) Amazon link to BB's:https://www.amazon.com/dp/B000HKKY7M?ref=emc_s_m_5_i_atc&th=1Assembly Instructions:Important: Rinse and dry the BB's or fishing weights in isopropyl alcohol to remove any oils. The print will pause at layer 121, fill the voids between infill evenly making sure to keep the weights below the top layer, wipe the top of the print with a clean rag damp with fresh isopropyl alcohol to avoid any adhesion issues, tap resume. Once the print is done a few drops of glue on the hanger tab will finish it