Thingiverse
Weighted iPhone MagSafe Dock
by johannchung
90
Downloads
94
Likes
2
Makes
Why it's so awesome?
It weighs >400g after being filled with some cement! One hand operations unlocked!
A bonus groove for slotting in some flexible fillament to make the base extra grippy!
Print settings (Stand.stl)
Settings
Value
Layer Height
0.15-0.2mm
Infill
0% (That's where the cement goes)
Ensure vertical wall thickness
Off (Not required for this model)
Seam
Rear
Special Treatment (See Attached Image)
Add a cylindar modifier to the top of the fill port and set it to 0 top & bottom layers, this will open up the fill port!
Print settings (Plug.stl)
Basically any normal settings would work
Attribution
Based on original model by jazzlw https://www.thingiverse.com/thing:4635725
It weighs >400g after being filled with some cement! One hand operations unlocked!
A bonus groove for slotting in some flexible fillament to make the base extra grippy!
Print settings (Stand.stl)
Settings
Value
Layer Height
0.15-0.2mm
Infill
0% (That's where the cement goes)
Ensure vertical wall thickness
Off (Not required for this model)
Seam
Rear
Special Treatment (See Attached Image)
Add a cylindar modifier to the top of the fill port and set it to 0 top & bottom layers, this will open up the fill port!
Print settings (Plug.stl)
Basically any normal settings would work
Attribution
Based on original model by jazzlw https://www.thingiverse.com/thing:4635725
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!