Thingiverse
Weighted storage/companion cube
von Skylled38
120
Downloads
92
Likes
4
Makes
# Portal weighted/companion cube
## Description
This is a remix from Ellindsey's design. I simply modified the faces to replace the heart by the Aperture logo.
## Parts to print
For each cube, you need :
* white_edge.stl (x12) : ~2.5 hours
* white_corner.stl (x8) : ~4 hours
* grey_corner.stl (x8, with supports) : ~3.5 hours
For the Weighted Storage Cube :
* blue_face_aperture.stl (x6) : ~1.25 hours
* white_face_aperture.stl (x6) : ~1.5 hours
For the Weighted Companion Cube :
* pink_face_heart.stl (x6) : ~1 hour
* white_face_heart.stl (x6) : ~1.25 hours
## Assembly
Glue not required.
1. Print all the parts
2. Put the gey_corners on the white_corners
3. Snap these two by two with the white_edges
4. Put the white_faces_ on the _faces
5. Create two squares, each with two step 3 assemblies and a step 4 assembly
6. On one of these squares, put white_edges on each corner
7. Snap the two squares together
# Print settings
## Quality
* 0.2mm layer hei
## Description
This is a remix from Ellindsey's design. I simply modified the faces to replace the heart by the Aperture logo.
## Parts to print
For each cube, you need :
* white_edge.stl (x12) : ~2.5 hours
* white_corner.stl (x8) : ~4 hours
* grey_corner.stl (x8, with supports) : ~3.5 hours
For the Weighted Storage Cube :
* blue_face_aperture.stl (x6) : ~1.25 hours
* white_face_aperture.stl (x6) : ~1.5 hours
For the Weighted Companion Cube :
* pink_face_heart.stl (x6) : ~1 hour
* white_face_heart.stl (x6) : ~1.25 hours
## Assembly
Glue not required.
1. Print all the parts
2. Put the gey_corners on the white_corners
3. Snap these two by two with the white_edges
4. Put the white_faces_ on the _faces
5. Create two squares, each with two step 3 assemblies and a step 4 assembly
6. On one of these squares, put white_edges on each corner
7. Snap the two squares together
# Print settings
## Quality
* 0.2mm layer hei
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
