Thingiverse
Wemos D1 Housing
von dirkvranckaert
14
Downloads
5
Likes
0
Makes
This is a housing for the Wemos D1. It's for the big board, not the mini!
The box has four pins to attach the Wemos board, I've printed and tested with a MakerBot Replicator Mini+ and you can gently push the board over the pins and it sits tight.
The lid comes in a few flavors.
1. Just the lid with a reset button hole
2. The lid with a reset button hole and DHT22 hole cut-out.
TODO: This thing is a work in progress. What I still want to do is to make some kind of tube above the led to have the led output only through that single hole in the lid.
The box has four pins to attach the Wemos board, I've printed and tested with a MakerBot Replicator Mini+ and you can gently push the board over the pins and it sits tight.
The lid comes in a few flavors.
1. Just the lid with a reset button hole
2. The lid with a reset button hole and DHT22 hole cut-out.
TODO: This thing is a work in progress. What I still want to do is to make some kind of tube above the led to have the led output only through that single hole in the lid.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
