Thingiverse
WEMOS D1 Mini 3D Printed Case
door theCoolTinkerMan
44
Downloads
24
Likes
0
Makes
A Simple 3D printed case for a WEMOS D1 Mini WiFi microprocessor board.
The design of this board is slightly different from the ones with the beveled corners. However, this case should fit the board with beveled corners as well.
The cover is a push fit and has slots on the longer edges that make the PINS and their labels visible.
You can fit the WEMOS board with or without the PIN rails soldered to the board. However, the case may have to be mounted on one of the sides.
One side of the case has a small opening to access the RESET pin.
The design of this board is slightly different from the ones with the beveled corners. However, this case should fit the board with beveled corners as well.
The cover is a push fit and has slots on the longer edges that make the PINS and their labels visible.
You can fit the WEMOS board with or without the PIN rails soldered to the board. However, the case may have to be mounted on one of the sides.
One side of the case has a small opening to access the RESET pin.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
