Thingiverse
Wemos D1 Switch
von pzucchi
0
Downloads
0
Likes
0
Makes
This is an enclosure for a WemosD1 + Buitton shield.
I use the button cap found here: www.thingiverse.com/thing:1958721 (not included).
No supports, just need to flip the top part upside down.
No fasteners: if your tolerances are not as mine you may need a drop of glue (or a bit of sandpaper).
I use the button cap found here: www.thingiverse.com/thing:1958721 (not included).
No supports, just need to flip the top part upside down.
No fasteners: if your tolerances are not as mine you may need a drop of glue (or a bit of sandpaper).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
