Wera Hex-Plus holder/storage for Multiboard

This is my third attempt at a holder/storage solution for the Wera Hex-Plus set, and so far I'm happy with the result. The keys are easy to grab and easy to put back. They're firmly held in place by the TPU insert without holding on to the keys too firmly.PrintingIn case you don't want to use the .3mf for whatever reason, here are some printing instructions: casing.stl & casing-bottom.stl:Walls: 3Walls printing order: Inner/Outer/Inner (for dimensional accuracy)Material: PLA or PETG tool_holder.stl:3 wallsHoneycomb 20% infillMaterial: TPU 95AInfill: 20% Honeycomb infillGood to knowThe tool_holder.stl has little nubs on it that is .1mm smaller in diameter than the holes in the casing.stl. If your filament isn't tuned well enough, the nubs can be a bit too thick to fit in the holes. It's supposed to be a tight fit, but if it doesn't work you'll need to tune your filament. The tool_holder's 20% honeycomb infill ensures enough rigidity to hold the keys in pl