Western Legends Set Pieces

Thank you https://www.thingiverse.com/TheBlueJackal for a great western themed set. As mentioned in a lot of the comments on the original post, it was tough to print most of the building as is. They were off-angle, not flat, and too small to print with FDM. I took the original design of the buildings and modified them to add some flare and print well with my printer.

I recommend printing the East and West Saloons as separate top and bottom pieces, and then glueing them together.

I leveled out the Mesas, but didn't adjust to fit better inside the red lines of the board. I'm going to try: https://www.thingiverse.com/thing:4092892 instead.


Hope you enjoy these for your game / train set / or just for fun!

:)