Slicer Discord
Westy Vent Flange – 3D-Druckmodell von Thingiverse Thingiverse

Westy Vent Flange

5 Downloads
1 Likes
0 Makes
Zum Modell
This is a ring that fits the kitchen vent of a 2004/2005 Airstream Sprinter Westfalia camper. It allows for the installation of a mosquito net and allows you to plug the hole to avoid draft.

It has three parts: the flange, an inner ring for mounting the mosquito net, and a plug.
After printing all parts, glue the mosquito net onto the ring, then epoxy glue the ring to the flange at an elevation such that the plug still goes in far enough to hold. Once glue has dried, remove the screws from the installed vent in the Westy.

When you have the vent screws removed take the opportunity to climb on the roof (can be easily reached through the main skylight) to clean the seal, check that the o-ring is still in good shape etc.

Now insert the assembled flange + net into the original flange, and put screws back in place. Be careful not to overtighten the screws lest the hull may get undue stress.

Happy travels!
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen