Wetsuit Hanger

The best and cheapest way to dry your wetsuit. On most commercial wetsuit hangers you fold you wetsuit in half, while most conventional clothes hangers made from plastic are not strong enough to hold a wetsuit and if they are, the arms hang down along the sides, trapping moisture. This hanger is cheap, compact, lightweight, and allows your wetsuit to dry with outstretched arms. To build a wetsuit hanger from this model, you need a length of 32mm empty conduit ("Leerrohr/Stangenrohr EN32" in German, piping to route electrical wiring in buildings). Get it from your local hardware store for 2-3€ Cut 2 pieces of equal length from the conduit, deburr the edges, glue in one end-cap per piece, glue one(!) piece of conduit into the printed middle-pipe. I used superglue. Feed a length of paracord (6mm) through the holes in the middle piece, knot in place and then knot a loop. I used two figure-eight knots to do this (see picture). To hang the wetsuit, stick the pipe with the 3d-printed