Thingiverse
Jewelry
Zum Modell
"whale" brooch
10
Downloads
8
Likes
0
Makes
I made a "whale" brooch
I have already made a lot of jewelry, but for this competition I wanted to make something new and different.
"whale" brooch the body part measures 5 cm, width of 3 cm is a depth of 2.23 mm
"whale" brooch the water part measures 7.9 cm by 2 cm and is 2.23 mm deep
19 min printing time for both parties
# ANYCUBIC3D
3D PRINTING SETTINGS
50% fill rate sufficient for jewelry
50% printing speed not too fast for better rendering
215 ° PLA printing temperature
60 ° plateau temperature
0.1 layer thickness
0.8 shell thickness
without support
I have already made a lot of jewelry, but for this competition I wanted to make something new and different.
"whale" brooch the body part measures 5 cm, width of 3 cm is a depth of 2.23 mm
"whale" brooch the water part measures 7.9 cm by 2 cm and is 2.23 mm deep
19 min printing time for both parties
# ANYCUBIC3D
3D PRINTING SETTINGS
50% fill rate sufficient for jewelry
50% printing speed not too fast for better rendering
215 ° PLA printing temperature
60 ° plateau temperature
0.1 layer thickness
0.8 shell thickness
without support
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
