Whetstone Guide for DMT Sharpener System

This is an adaptation of the shetstone guide from Isambard11 to my DMT diamond whetstones.

As these are quite small, I have optimized the design so that I can use as much of the sharpening stone's surface as possible.

I have included the CAD for sliders with other angles. All you have to do is enter the desired angle in the parameters spreadsheet. As I am not a designer, the CAD file is not 100% professional.

### Shopping list:
* 2x stainless steel rod, 6 x 200mm
* 4x linear bearing, LM6UU 6x12x19mm
* 4x screws ~ 3x3mm (optional, 3x10mm are shown in the picture)

* Whetstones: https://www.schmiedeglut.de/6-Diamond-Whetstone-3er-Set-in-Holzkiste

### Printing:
Easy to print. No supports or other stuff necessary. I printed it with PLA on a Creality K1 Max with 3 wall loops and 3 top and bottom layers at 15% infill.

### Post processing:
Insert the linear bearings into the slider. Then insert it into the rods and insert them into the two parts. Optionally fix with scr