Slicer Discord
Wicca / Witches Cookie Cutters – 3D printable model from MakerWorld MakerWorld
Other House Models

Wicca / Witches Cookie Cutters

4 Downloads
5 Likes
2 Makes
Go to Model
Wicca, the religion of witches, mysterious and unknown. With the introduction of wiccan symbols into popculture and goth aestethics, you might have been in the position, where you wanted to bake some of the symbols into cookies. Well now you can with this set of cookie cutters! The cookie cutters are designed for thinner doughs of 4-6mm thickness. Some shapes are more difficult to get a good imprint of than others. Make sure to cover the cutter side with flour and roll your dough onto flour or a different non-stick surface. The dough should also not be too wet, sind that will make it way harder to get the dough ot without damage. If the dough is stuck, try tapping the cutter from the upper side repeatedly (maybe with some force), until the cut cookie comes out. Print from PETG for it to be cleanable with hand warm water. Clean thouroughly after each use as FDM prints are prone to bacteria! Not dishwasher safe (max 60°C) !
Category
Other House Models
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PETG, Polycarbonate
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

ueda also publishes on

134 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection